ATH-1102 semi-synthetic coolant
ATH-1102 semi-synthetic coolant
- Same-day dispatch for orders before 15:00
- Genuine product, invoiced sale
Product description
ATH-1102
Semi-Synthetic Cutting and Cooling Fluid (Soluble Oil)
Properties
- Resistant to corrosion and wear.
- Cooling and cutting performance is high.
- Resistant to hard water.
- Tramp oils such as slideway oil are not emulsified.
- Contains no nitrile, phenol or formaldehyde.
- Contributes to cutting edge life.
- Assists chip evacuation.
Application
- Under normal conditions it is mixed into water at 5 % (refractometer ~3.5).
- Top-up emulsion is prepared externally.
- For differing operating conditions the emulsion ratio is determined by trial.
Warnings
- Before the fluid is applied, the machine and the fluid tank, including the hoses, must be disinfected.
- The emulsion must be checked frequently.
- The machine must not be run without an oil skimmer.
- Interrupting machine operation shortens fluid life.
- The packaging is kept out of sunlight.
- Spent chemical and its packaging are disposed of in line with environmental regulations.
- Protective clothing and safety glasses are worn to prevent skin contact.
Pack size and price: The pack size (litres/kg) and the current list price are stated with the quotation.
Related Technical Guides
For choosing the right tool and working with the right parameters
Surface Roughness (Ra, Rz) and Finish Milling: Theoretical Calculation, Stepover Selection and Measurement
What Ra, Rz and Rmax actually measure, the changes brought by the ISO 21920 series, theoretical roughness calculated from nose radius and feed, scallop height and stepover selection in ball nose milling, and the cut-off rules.
13 min read
Trochoidal Milling and High Efficiency Machining (HEM/HSM): Engagement Angle, Parameters and MRR Calculation
The low radial, high axial engagement principle; engagement angle and chip thinning correction, material removal rate compared against full slotting, CAM naming conventions and machine tool requirements.
11 min read
Milling Titanium and Heat-Resistant Alloys (ISO S): Parameters, Cooling and Safety
In ISO S materials such as Ti-6Al-4V and Inconel 718, heat builds up on the cutting edge instead of leaving with the chip. Cutting speed limits, high-pressure coolant, trochoidal engagement control, notch wear and the risk of chip fire are covered together.
11 min read
